Steca RCC-02 remote control and display

Lots of information on the status of the system can be retrieved using the graphic display of the Steca RCC-02. Any incidents within the system are also saved and displayed. This means that any problems which might occur are identified early.

Operating Instructions

Data Sheet

Steca PA Tarcom

Data logger
The Steca PA Tarcom data logger is connected to the RJ45 interface of the Steca Tarom or Power Tarom charge controller, or via the Steca PA HS200.

Operating Instructions

Data Sheet

Steca PA HS200

Shunt
The Steca PA HS200 is a highly intelligent current sensor with extremely low own consumption.

Operating Instructions

Data Sheet

Steca PA 15

Remote control
The Steca Tarom and Power Tarom charge controllers send out signals (125 kHz on 300 Baud) which are modulated on the DC cable and received by the Steca PA 15 remote control.

Operating Instructions

Data Sheet

Steca PA EV200 DC

12 V / 24 V, 36 V / 48 V DC relay
The Steca PA EV200 relay increases the switching capacity of the Steca PA 15 remote control from 15 A to 200 A (up to 10 kW).

Data Sheet

Steca PA IRS 1008/180

Motion detector
The Steca PA IRS 1008/180 motion detector is connected to the load output of the night light charge controller. This supplies power to the light, which is then turned on for a few minutes when some movement is detected.

Data Sheet

Steca PA RC100

Remote control
For Steca Solsum F, Steca Solarix PRS und Steca Solarix MPPT.

Steca PAx4

Parallel switch box
Up to four Steca Solarix PI can be operated in parallel. The connections are made via an external box, the Steca PAx4.

Operating Instructions

Data Sheet